您現在的位置：機床商務網>技術中心>操作維修
搖臂鉆立柱夾緊調整
搖臂夾緊調整
主軸箱夾緊
Hydraulic rocker drilling column clamp tight and troubleshooting
Cause analysis: spring 3 screws on the tune too much, so that the upright post too much, rhombic block clamping mechanism cannot be inside and outside column with conical compression; adjusting nut 6 adjustable inappropriate, so that the lever 13 and the shell creates a gap between; hydraulic system in the oil pressure is too small, cannot push oil cylinder set the piston is rhombic block, not in the clamping position.
Elimination: reset spring board by screws, but to ensure that the rocker arm during a release of the force, and then adjust the column on the nut so that the clamping force to reach 1568N （ in the arm end thrust ） and then screw locknut; if the column is released is light, to adjusting nut 6, reduce the gap between the lever and the housing, then the nut 7 of 4 screws; adjusting hydraulic system of pressure oil assurance in 245-291x10000pa or replace the oil in the oil tank.
Note: screws, nuts see manual annotation
上一篇：磁性排屑機的工作原理
- 凡本網注明"來源：機床商務網"的所有作品，版權均屬于機床商務網，轉載請必須注明機床商務網，//www.tiger-pot.com/。違反者本網將追究相關法律責任。
- 企業發布的公司新聞、技術文章、資料下載等內容，如涉及侵權、違規遭投訴的，一律由發布企業自行承擔責任，本網有權刪除內容并追溯責任。
- 本網轉載并注明自其它來源的作品，目的在于傳遞更多信息，并不代表本網贊同其觀點或證實其內容的真實性，不承擔此類作品侵權行為的直接責任及連帶責任。其他媒體、網站或個人從本網轉載時，必須保留本網注明的作品來源，并自負版權等法律責任。
- 如涉及作品內容、版權等問題，請?jiān)谧髌钒l(fā)表之日起一周內與本網聯系，否則視為放棄相關權利。
